macro.catchAbort
Introduced in version 1.5.0. The variable macro.catchAbort can be used to override the default abort()
function to continue execution post abort()
statement.
Wherever you set macro.catchAbort
to any subsequent call to another macro using abort()
will not abort the current macro. So the abort is caught and the calling macro will proceed with execution.
The variable macro.catchAbort must be in the variable scope where the abort should be caught. It is not a general flag to turn off abort behavior; just temporarily in the macro or variable scope where it's set.
Usage
Set this variable to 0 (default abort behaviour) or 1 (catch aborts).
[h: macro.catchAbort = 1]
[h: macro.catchAbort = 0]
Examples
When a macro is called by another macro, the called macro may use the abort() to cancel execution. Usually all macro execution would stop, so the calling macro would not continue. We can now override that default behavior by catching the abort.
Default behaviour
The macro below will not have any output because the default behavior is that any call to abort will stop the overall macro execution. Whatever code is defined after the call to abort is not executed.
Default abort Macro |
---|
[h: resultText = "defaultValue"]
[h: resultText = abort(0)]
[r: resultText] |
Catch the abort
The macro below will output "defaultValue" as the macro.catchAbort
set to 1 preventing the call to abort() from actually terminating execution. The example shows how to set a default value for any return value of a function/macro that has a abort call in it. The macro then re-enables the normal function of abort() again by setting macro.catchAbort
to 0. As each macro has its own variable scope, this only affects calls to abort() within the current macro or calls to other macros from the current macro.
Catching abort |
---|
[h: macro.catchAbort = 1]
[h: resultText = "defaultValue"]
[h: resultText = abort(0)]
[r: resultText]
[h: macro.catchAbort = 0] |
Catch the abort with 2 macros
Same as in the above example, the calling macro below will output "defaultValue" cause we activate catching aborts (in anything that this macro will call afterwards) with macro.catchAbort
set to 1 .
Called macro using an abort as function doSomething() | Calling macro catching an abort |
---|---|
[h: "this macro will do something and then abort"]
[h: "... doing something"]
[h: abort(0)] |
[h: macro.catchAbort= 1]
[h: resultText = "defaultValue"]
[h: resultText = doSomething()]
[r: resultText]
[h: macro.catchAbort= 0] |
See also
Version changes
- 1.5.0 - introduced macro.abortCatch